Rice Cooker; Cooking Plate - Tiger JKT-S Série Mode D'emploi

„ Installing the steam cap gaskets
Set the gaskets securely onto the steam cap as
shown in the figure below. If the gaskets are not
set securely, they can become loose and this may
result in problems due to steam leaking out, etc.
Note
● Do not remove the O-ring. If it is removed, set it back
in place securely.
If it is difficult to attach, slightly moisten the O-ring with
water to make it easier to attach.
Removing odors
The following procedure should be performed each time after cooking, or if odors become bothersome.
Note
● Be careful of the hot inner pot, cooking plate, and rice cooker after cleaning. Touching them may result in
burns.
„ Rice cooker
Do not place the cooking plate inside the inner pot.
1
Fill the inner pot to about 70
to 80% with water, select the
"Plain" menu and press the
[Start/Rinse-free] key.
Confirm that the Keep Warm
lamp is on and press the
[Cancel] key.
Note
● If odors become bothersome, use about 0.71 oz (20
g) of citric acid added to the water for more effective
deodorizing.
It may be impossible to remove some odors
completely. In this case, contact the place of
purchase.
2
Wash the inner pot, inner lid,
and steam cap with a standard
kitchen detergent, and then
rinse sufficiently with water.
(When odors remain in the rice cooker and/or cooking plate)
3
„ Cooking plate
Immerse the cooking plate in hot water and allow it
to soak for about 1 hour.
Small gasket
Large gasket
Allow the rice cooker and all
parts to dry in a well-ventilated
location.
Steam
cap
O-ring
41 41