Replacing The Lamp - FUST NOVAMATIC KS162-IB Notice D'utilisation

49
Problem
Water flows on the floor.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

Replacing the lamp

Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
Possible cause
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
3. Replace the used lamp with a new lamp
of the same power and specifically
designed for household appliances (the
maximum power is shown on the lamp
cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Solution
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water out-
let to the evaporative tray.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.