Replacing The Lamp; Installation - FUST NOVAMATIC KS-TF 309-IB Notice D'utilisation

Masquer les pouces Voir aussi pour NOVAMATIC KS-TF 309-IB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

43
Problem
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easily.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

Replacing the lamp

The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION! Disconnect the plug
from the mains socket.
1. Pull the left side of the lamp cover with
your fingers to unlock it. Remove the
cover by pulling it towards yourself.

INSTALLATION

WARNING! Refer to Safety
chapters.
Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
Possible cause
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
You attempted to re-open
the door immediately after
closing.
2. Replace the bulb with one of the same
power and shape, specifically
designed for household appliances.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.
class indicated on the rating plate of the
appliance:
Cli‐
mate
class
SN
Solution
Open the door only when nec‐
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag‐
ing before storing it in the ap‐
pliance.
Wait a few seconds between
closing and re-opening of the
door.
1
2
1
Ambient temperature
+10°C to + 32°C

Publicité

Chapitres

Table des Matières
loading

Table des Matières