Remove Transport Lock 1; Set Up Mobile Version (If Available); Assembly Of The Optional Clampholder; Set Up The Safety Set - Medela Dominant Flex Mode D'emploi

5.2
Remove transport lock 1�
5.3
Set up mobile version
(if available)
5.4
Assembly of the
optional clampholder
(when using the
optional trolley)
5.5

Set up the Safety Set

14 |
Installation
1�
2�
1�
1�
1�1
1�2
2�
1�1 Remove the red note
1�2 Remove 3 screws and
store them for later use�
1�1 Position top part of trolley
on bottom part, making
sure the tubing fits as
shown�
1�2 Connect parts with
4 screws�
2�1 Position pump on trolley�
Make sure that the front of
the pump and the
standard rail point
forward�
2�2 Connect pump with
4 screws�
2�3 Attach the cable holder
with the two screws to the
pump�
1�1 Press and hold the blue
release knob�
1�2 Attach the clampholder to
the standard rail by
releasing the blue knob�
1�1 Attach the mechanical
1�3
overflow protection to
the lid� Pull gently down-
wards to make sure it is
open / deactivated�
1�2 Attach the lid to the jar�
1�3 Close the two lid clamps�
2�1 Attach the Safety Set to
the pump�