Safety Instructions; Annex "I Technical Documentation (Emc)" - Medela Dominant Flex Mode D'emploi

Safety instructions

– The Medela Dominant Flex is a medical device that requires special safety measures in regard
to EMC� It must be installed and put into operation in accordance with the EMC information in
annex "I Technical documentation (EMC)"�
– In the case of overflow, inform the internal technical service immediately and
perform the tasks in the service manual�
– In each of the following cases, the device must not be used and it must be repaired by Medela
Customer Service:
– if the power cord or the plug are damaged
– if the device is not functioning perfectly
– if the device is damaged
– if the device shows clear safety defects�
– Keep the power supply cord away from hot surfaces�
– The mains plug must not come into contact with moisture�
– Never pull the mains plug out of the fixed mains socket by pulling on the power supply cord!
– Never leave the device unattended when it is switched on�
– The pump must stand upright during use�
– Never use the device at high room temperatures, while bathing or showering, if you are very
tired or in an environment where there is a risk of explosion�
– Never place the device in water or other liquids�
– When using single use, sterile products, please note that they are not intended to
be reprocessed� Reprocessing could cause loss of mechanical, chemical and / or
biological characteristics� Reuse could cause cross contamination�
– Contact your local Medela customer service representative for assistance with product opera-
tions�
These instructions for use must be kept for later reference�
8 |
Warnings and safety instructions