Lk8 Light Installation (Optional) - Napoleon GT8N Instructions D'installation Et D'opération

6.6

LK8 LIGHT INSTALLATION (OPTIONAL)

Turn off the electrical and gas supply to the appliance.
A.
Remove the frame from the appliance by removing the 2
B.
black securing screws from the top, and the 2 silver hex
head securing screws from the bottom.
Lay the frame down on its front, being careful not to
C.
scratch the fi nish.
Starting at the top of the frame, take one light assembly
D.
and carefully snap it into place in the hole provided.
Repeat for each of the light assemblies. The wires on
the top 2 light assemblies will need to be fed in behind
the heat shields.
NOTE: When installing the light kit be careful not to scratch
your fi ngers on any of the exposed screws in the frame.
Using illustration as a guide, connect the light
E.
assemblies to the appropriate fl ags on the wire harness.
The wire harness is labeled (TR) top right, (BR) bottom
right (TL) Top left and (BL) bottom left.
Secure the wires into the clips at both sides and the
F.
bottom of the frame. Use the extra clips provided to
retain any loose wires.
Re-attach frame onto appliance.
G.
Remove the control panel by removing the 2 screws
H.
securing it along the top edge. Leave the wires
connected to the ON/OFF switch.
Place the transformer into the bottom of the appliance.
I.
Plug the transformer into the receptacle.
Lay the control panel fl at along the bottom edge of the
J.
frame. Attach one of the wire leads from the transformer
to the lead on the wire harness labeled "TRANS", and
the other to the ON/OFF switch. Attach the last lead on
the wire harness labeled "SWI" to the ON/OFF switch.
Re-secure the control panel.
K.
Turn on the gas supply and electrical power.
L.
29
CLIPS X5
W415-1367 / 12.05.14
EN