Installation; Bulkheads; Night Light™ Installation - Napoleon B81NL-1 Manuel D'installation Et D'utilisation

2.3

bulkheads

note:
Bulkhead covers need to be removed.
Connect the gas flex lines and the pilot line
A.
to the gas bulkheads located under the valve
access opening. Be sure to match up the gas
manifold marked with a painted dot with the
center bulkhead, also marked with a painted
dot. Care must be taken to ensure the pilot
line isn't damaged and ensuring gas tight
connections are made.
Connect the pilot electrode leads to the
B.
bulkhead matching the 1/4" flag with the 1/4"
bulkhead spade and the 3/16" flag with the
3/16" spade.
Ensure the 2 venturi tubes are over the orifices
C.
before lighting.
Check for gas leaks by brushing on a soap
D.
and water solution. Do not use open flame.
After leak test has been performed reinstall
E.
access panel with gasket.
2.4 night light™ installation
The HD81-1 comes equipped with two "Night Lights™". The lights have been pre-wired and are controlled from
the remote control.
If in the event the lamps or lens need replacing, follow the instructions below:
A. Shut off breaker at main power supply
B. Remove the four screws that secure the lens frame to the firebox sides. This frame retains the glass lens.
C. The lamp can now be accessed.
note:
Do not handle the lamp (bulb) with bare fingers, protect with a clean, dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special "high
temperature" products. When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens. "Light Leakage" from the holes in the housing lamp may be
observed. The holes in the lamp housing are necessary for ventilation and must not be covered.
All manuals and user guides at all-guides.com
GASKET
LENS
FRAME

installation

Gas
Bulkheads
Pilot
Bulkhead
Pilot
Electrode
Leads
See Thru
Window
Venturi
Tube
JOINT
D'ÉTANCHÉITÉ
LENTILLE
CADRE
NIGHT LIGHTS
W415-0713 / E / 05.10.18
EN
Painted
Dots
Pilot
Electrode
Orifice
3