Frame/Front Installation - Napoleon GT8N Instructions D'installation Et D'opération

6.4

FRAME/FRONT INSTALLATION

Align the two holes in the upper portion
A.
of the hinge on the control door to those
in the bottom trim bracket, secure using
two of the #8 x 1/2" hex head screws
supplied.
Install the top trim bracket to the fi rebox
B.
using the three #9 - 14 x 1/2" hex head
screws supplied in the
baggie.
Rest the top lip of the
C.
the top trim bracket, and the securing tabs at the bottom
of the
Align the two slots in the top of the
D.
using the two #10 pan head screws supplied however do not fully tighten to leave room for adjustment.
Align the holes in the securing tabs at the bottom of the
E.
bracket and secure using the two remaining #8 x 1/2" hex
head screws, however do not fully tighten to leave room for
adjustment.
If required, the bottom trim bracket can be adjusted by
F.
loosening it's securing screws.
Once the
G.
door will close without rubbing against the sides of the
frame, tighten all screws.
Open the control door.
H.
Insert the door stop chain into the receiving slot in the
I.
control door.
Insert the door stop chain into the receiving slot in the
J.
frame so that when fully open the control door has
a clearance of 1/8" to the fi nished wall. NOTE: In most
cases, a count of 9 balls between receiving slots will
give the desired clearance.
Close the control door.
K.
The frame has been designed to accommodate fi nished
material thicknesses of 1/2" - 3/4" (13mm - 19mm). If it is
necessary to pull the
the magnetic catch will need to be adjusted. Minor adjustment
can be made by removing shims from behind the magnet. Major
adjustments can be made by moving the magnet to the outside of
the panel.
Adjustment may be required to accommodate the door stop
chain slack when the control door is closed. The control
door securing screws can be loosened to allow
adjustment. Before
re-tightening the
screws ensure the
control door is still
recessed into the
frame at a
similar offset to the
top trim piece.
manual
frame on
frame on the bottom trim bracket.
frame is perfectly square and the control
frame out to the max. 3/4" (19mm)
BOTTOM
TRIM
BRACKET
CONTROL
DOOR
frame with the two holes in the top trim bracket and secure
frame with the holes in the bottom trim
TOP
TRIM
BRACKET
27
TOP
TRIM
BRACKET
EN
BOTTOM
TRIM
BRACKET
W415-1367 / 12.05.14