Optional Installation; Optional Spark Screen Installation - Napoleon HIGH COUNTRY NZ3000 Instructions D'installation Et D'opération

28

7.0 OPTIONAL INSTALLATION

7.1

OPTIONAL SPARK SCREEN INSTALLATION

EN
NEVER LEAVE APPLIANCE OPERATING UNSUPERVISED WITH SPARK SCREEN IN PLACE.
USE CAUTION WHEN PLACING THIS SPARK SCREEN ON AN OPERATING APPLIANCE.
USE ONLY APPROVED WOLF STEEL OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES AND REPLACEMENT PARTS (BLOWERS,
DOORS, LOUVRES, TRIMS, GAS COMPONENTS, VENT COMPONENTS, ETC.) COULD RESULT IN A
Use the spark screen when you are in the room to enjoy the ambience of an
open, wood crackling fi re.
Medium sized wood loads should be used to prevent logs
from rolling against the spark screen.
Chimney action may not allow the spark screen to be used
in some installations due to the resulting smoke spillage.
Wood will burn at a faster rate and heat output will be
less with the spark screen compared to the appliance
operation with the glass doors closed.
Do not use any type of wood that produces excess
sparks. (ie. Cedar)
Spark screen must be removed in order to close the
glass operating doors.
A. Open the glass operating doors.
B. Tilt the top of the spark screen forward and slide the top clip behind the top edge of the appliance
opening.
C. Swing the bottom of the spark screen into position, allowing the bottom clip to rest on the bottom
opening.
W415-0711 / D / 05.09.13
TURN OFF THE BLOWER BEFORE OPERATING WITH THE SPARK SCREEN.
SAFETY HAZARD AND WILL VOID THE LIMITED LIFETIME WARRANTY.