Zanussi ZDI15001 Notice D'utilisation page 10

• All the programme indicators are on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C) at
the same time until the appliance is in setting
mode.
Starting a programme without delay start
1. Open the water tap.
2. To set a programme, keep the appliance
door ajar.
3. Press the on/off button to activate the appli-
ance. The on/off indicator comes on.
4. Make sure that the appliance is in setting
mode.
5. Press the button of the programme you
want to set.
• The related programme indicator comes
on.
• The wash indicator comes on.
6. Close the appliance door. The programme
starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until
the indicator of the number of hours you
want to set flashes. You can set 3, 6 or 9
hours.
3. Close the appliance door. The countdown
starts.
• The delay indicator stops flashing.
• The wash indicator goes off.
• When the countdown is completed, the pro-
gramme starts.
– The wash indicator comes on.
– The delay indicator goes off.
You can set a programme and the delay
start also with the appliance door closed.
In this condition, you have only 3 seconds after
each setting before the appliance starts to op-
erate.
10
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance contin-
ues from the point of interruption.
Cancelling the delay start
Press and hold function buttons (B) and (C) at
the same time until the delay indicator goes off
and all the programme indicators come on.
When you cancel a delay start, the appli-
ance goes back to setting mode. You have
to set the programme again.
Cancelling the programme
Press and hold function buttons (B) and (C) at
the same time until all the programme indica-
tors come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, the end in-
dicator comes on and the wash indicator goes
off.
1. Press the on/off button to deactivate the
appliance. The on/off indicator goes off.
2. Close the water tap.
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and on
the door of the appliance. Stainless
steel becomes cool more quickly than
the dishes.
www.zanussi.com