Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
German
degrees
(°dH)
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the appli-
ance. The on/off indicator comes on. Make
sure that the appliance is in setting mode.
Refer to 'SETTING AND STARTING A
PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) flash.
3. Press function button (A).
• The indicators of function buttons (B)
and (C) go off.
• The indicator of function button (A) con-
tinues to flash.
• The end indicator flashes showing the
setting of the water softener.
www.zanussi.com
Water hardness
French
mmol/l
degrees
(°fH)
26 - 32
2.6 - 3.2
19 - 25
1.9 - 2.5
7 - 18
0.7 - 1.8
< 7
2
Turn the water hard-
ness dial to the posi-
tion 1 or 2.
Clarke
degrees
18 - 22
13 - 17
5 - 12
< 0.7
< 5
– The number of flashes of the end indi-
cator shows the level of the water soft-
ener.
Example: 5 flashes + pause + 5 flash-
es = level 5.
4. Press function button (A) again and again
to change the setting. Each time you press
function button (A) you go to the next level.
5. Deactivate the appliance to confirm.
Filling the salt container
Caution! Only use dishwasher salt. Other
products can cause damage to the
appliance.
Water and salt can come out from the salt
container when you fill it. Risk of corrosion. To
prevent it, after you fill the salt container, start a
programme.
1
Water softener
adjustment
Manual
Elec-
tronic
1
4
1
3
1
2
2)
2)
1
1
2
7
Publicité
Chapitres
Table des Matières
