Before First Use - Zanussi ZDT 16011 FA Notice D'utilisation

4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
Acoustic signals
The acoustic signals operate in these condi-
tions:
• The programme is completed.
• The level of the water softener is adjusted
electronically.
• The appliance has a malfunction.
Factory setting: on. You can deactivate the
acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
If you use the combi detergent tablets, ac-
tivate the multitab function. These tablets
contain detergent, rinse aid and other added
agents. Be sure that these tablets are applica-
German
degrees
(°dH)
51 - 70
www.zanussi.com
Water hardness
French mmol/l
degrees
(°fH)
91 - 125 9.1 - 12.5
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) flash.
3. Press function button (C),
• The indicators of function buttons (A)
and (B) go off.
• The indicator of function button (C) con-
tinues to flash.
• The display shows the setting of the
acoustic signals.
4. Press function button (C) to change the
setting.
5. Deactivate the appliance to confirm.
ble to the water hardness in your area. Refer to
the instructions on the packaging of the prod-
ucts.
Adjusting the water softener
Hard water contains a high quantity of minerals
that can cause damage to the appliance and
bad washing results. The water softener neu-
tralises these minerals.
The dishwasher salt keeps the water softener
clean and in good conditions. Refer to the table
to adjust the water softener to the right level. It
makes sure that the water softener uses the
correct quantity of dishwasher salt and water.
You must adjust the water softener man-
ually and electronically.
Clarke
degrees
64 - 88
On
Off
Water softener
adjustment
Manual Elec-
tronic
1) 10
2
19