7.1 General Transmitter Layout; 7.2 Initializing The Transmitter/Battery Holder; 7.3 Tempature Display; 12 7.7 Key Lock - Napoleon STARfire Série Manuel D'installation Et D'opération

Masquer les pouces Voir aussi pour STARfire Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.0 operation
EN
7.1
general transmitter layout
Transmission
Flame ON
7.2
initializing the transmitter/battery holder for the fi rst time
A.
Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and insert as
indicated on the cover (+/-).
B.
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
marked PRG, as shown in the illustration below.
D.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
note:
The initializing process must be completed within 10 seconds of pressing the reset/program button (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
7.3
tempature display
A. With the system in the off position, press the Temperature Key and the
mode key at the same time to change from degrees F to C.
B. Look at the LCD screen on the transmitter to verify that a C or F is
visible to the right of the Room Temperature display.
38
W415-2363 / A / 11.01.19
Blower
Key Lock
Low battery alarm
Low Battery Alarm
Room
Temperature
CPI mode
Light
TRANSMITTER
°F
73
°C
23

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Starfire hdx52nt-2Starfire hdx52pt-2

Table des Matières