maintenance
EN
10.7
night light replacement
Your appliance came equipped with our "NIGHT LIGHT". The light has been
wired and can be controlled by remote control.
It is recommended that the NIGHT LIGHT be in the off position when the
appliance is on.
If in the event the lamp or lens needs to be replaced, follow the
instructions below.
A.
Shut off the electrical supply to the fi replace.
B.
Remove the 2 screws securing the relief door supports.
C.
Carefully remove the relief door gasket.
NOTE: A new gasket may be required if damaged
(W290-0239).
D.
Remove the 4 screws that secure the lens frame.
This frame retains the glass lens. The lamp can now
be accessed.NOTE: Do not handle the lamp
(bulb) with bare fi ngers, protect with a clean
dry cloth.
E.
The lamp will pull straight out of the socket.
Replace with Wolf Steel parts only, as lamp
and lens are special "high temperature" products.
F.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
NOTE: Over tightening the screws could break the
lens.
48
W415-2363 / A / 11.01.19
pre-
SCREWS
FIREBOX
RELIEF DOOR
GASKET
LENS
FRAME
RELIEF DOOR
GASKET
RELIEF DOOR
SUPPORT