Safety Screen Removal / Installation; Finishing - Napoleon STARfire Série Manuel D'installation Et D'opération

WARNING
!
• Risk of fi re!
• Never obstruct the front opening of the appliance.
• The front of the appliance must be fi nished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specifi ed dimension, as illustrated.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
• Facing and/or fi nishing material must never overhang into the appliance opening.
• The glass door assembly is a safety device designed to pivot forward when relieving excess pressure that
might occur. Finishing or other materials must not be located in the opening surrounding the door as this will
interfere with the doors ability to relieve pressure.
• If applicable, drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must
be taken to prevent drywall dust from coming into contact with the blower or its compartment. Any damage
resulting from this condition is not covered by the warranty policy.
5.1

safety screen removal / installation

WARNING
!
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with the
appliance and must be installed.
A.
There are 4 hanging tabs
securing the safety screen onto
the door. The tabs are on the
right and left sides of the door.
B.
Lift up and pull the safety screen
away from the appliance to
remove it from the slots in the
main door, refer to Figure 1.
C.
Reverse this process to install
the safety screen back onto the
appliance.
SAFETY
BARRIER
5.0 fi nishing
FIG. 1
GLASS DOOR
31
W415-2363 / A / 11.01.19
EN