Toxic And/Or Dangerous Liquid Dosage; Assembling And Dismantling The Pump; Dismantlement - ETATRON D.S. BH3-V Notice D'installation, Emploi Et Entretien

1.5 - TOXIC AND/OR DANGEROUS LIQUID DOSAGE

To avoid risk from contact with the hazardous liquids or toxic fumes, always adhere to the notes in this instruction
manual:
• Follow the instructions of the dosing liquid manufacturer.
• Check the hydraulic part of the pump and use it only if it is in perfect condition.
• Use only the correct ma terials for the tu bing, valves and seals to suit the
shield the tubing with PVC conduit.
• Before disco nnecting the metering pump, make sure to flush o
proper reagent liquid.

1.6 - ASSEMBLING AND DISMANTLING THE PUMP

1.6.1 - ASSEMBLY
All metering pumps are normally supplied fully assembled. For greater clarity, please consult the explod ed view
of the pump append ed at the end of t he manual, which s hows all the pu mp details and a complete overview of
all the pump components. These drawings are in any
to be re-ordered.

1.6.2 - DISMANTLEMENT

Proceed as follows before you dismantle the pump or before performing any other operation on it:
1. Disconnect the plug from the main s or by means of a o nnipolar switch with 3 mm minimum distance between
the contacts. (Fig. 4).
2. Relieve all the pressure from the injection tube.
ut and n eutralize the pump head with the
case quite indispensable whenever defective parts have
• 11 •
liquid to b e dosed; where possible