Assembly Procedure - Rehau RAUTOOL H2 Mode D'emploi

rautool h2

assembly procedure

Failure to observe these instructions may result in damage to the jointing systems, to the tool and personal injury .
1. Using pipe cutters, cut pipe to required length at right angles and
without leaving burrs.
Caution:
Keep your hand at a safe distance from the tool. Do not use saws or
similar!
2. Slide compression sleeve onto pipe.
Caution:
On metal compression sleeves, the inner chamfer must point towards
the connection.
3a. Expand pipe using expander, rotate 30°, and repeat once. The
min. distance between expander head and compression sleeve must
be two compression sleeve lengths.
3b. Expand pipe using expander bit, rotate 30°, and repeat once. The
min. distance between expander head and compression sleeve must
be one compression sleeve lengths.
4. Insert fitting into pipe up to the stop. After a brief period the fitting
will sit tightly in the pipe (memory effect).
Caution:
All sealing ribs must be covered! Until the memory effect has set in
completely, the fitting can still fall out of the pipe! Make sure that the
fitting is correctly seated.
27