Tool Preparation - Rehau RAUTOOL H2 Mode D'emploi

rautool h2

tool preparation

Caution! Risk of injury!
Improper handling of the REHAU tool can cause harm to people
and/or the tool .
- During every change of the jaw sets, make sure that the pins are
inserted completely and safely.
- Before each use, check the jaw sets, expander bits, expander sets
and the tool for damage or visible wear. Damaged tools must no
longer be used and should immediately be sent to an authorized
service center for repair.
Expanding tool
Expander:
When changing expander heads
open expander completely
(> 90° position). Always screw
expander heads fully on. Use
expander heads of a size confor-
ming to the pipe dimensions (for
example 16 x 2.2)
Attention!
Always insert the expanding tool
into the pipe up to the stop!
- When introducing the expander bit, always insert it completely into
the compression jaws.
- The entire surface of the receiving groove of the bit must lie in the
compression jaws.
- Before actuating the tool, check to make sure that the seating and
clamping action of the bit are correct (to avoid falling out).
If necessary, increase the compression effect by brief activation of
the operating switch on the tool.
Expander bit
When introducing the expander
bit for hydraulic expansion,
always insert it (make sure size
matches) completely into the
corresponding compression jaws
and check for fitting (clamping).
25