Assembly Procedure - Rehau RAUTOOL M1 Mode D'emploi

ASSEMBLY PROCEDURE

Failure to observe these instructions may result in damage to the jointing technique, to the tool and in personal injury.
1. Using the pipe cutter, cut the pipe to required length at right angles
and without leaving burrs.
Caution:
Keep your hand at a safe distance from the tool. Do not use saws or
similar equipment!
2. Push the compression sleeve over the pipe
Caution:
With metal compression sleeves, the inside chamfer must point to-
wards the joint.
3. Expansion with expanding pliers QC:
Expand the pipe, rotate 30° and repeat.
The minimum distance between expander head and compression
sleeve must be two compression sleeve lengths.
4. Insert fitting into pipe up to the stop. After a brief period, the fitting
will sit tightly in the pipe (memory effect).
Caution:
All sealing ribs must be covered. The fitting may fall out of the pipe
until the memory effect is fully functional! Ensure the fitting is in a
straight position!
Fully insert the joint into the clamping tool.
Caution:
Do not tilt! Tool must be applied the entire surface and at right angles.
23