Güde GHS 520 18 LI-ION Traduction Du Mode D'emploi D'origine page 12

Package:
Protect against moisture
Residual risks and protective measures
Electric residual risks
Threat Description
Direct electrical Electric shock Safety switch against FI
contact
Indirect Electric shock
electrical through a
contact medium
Disposal
The disposal instructions are based on icons placed on the
appliance or its package. The description of the meanings
can be found in the "Marking" chapter.
Do not put the electric appliance to household waste!
Electric appliances must be collected separately and
recycled in an environment friendly manner according to
the European Directive 2002/96/EG on used electric and
electronic appliances and its application in the national
law.
Operating staff requirements
The operator must carefully read and understand the
Operating Instructions before using the appliance.
Qualification: No special qualification is necessary for
using the appliance apart from detailed instruction by an
expert.
Minimum age: The appliance can only be operated by
persons over 16 years of age. An exception includes
youngsters operating the appliance within their
professional education to achieve necessary skills under
trainer's supervision.
Training
Using the appliance requires only corresponding
instruction by a professional or reading the Operating
Instructions. No special training necessary.
Technical specification
Accumulator: 18 V / 1,300 mAH ( Li-Ion )
Charger: 3-5 hours
Trimming length: 520 mm
Knife hole: 14 mm
Trimming width: app. 12 mm
Delay: app. 50-55 min.
Noise level L 94 dB
WA
Weight: 3.3 kg
Transport and storing
Store the appliance in a dry condition, with no rust,
out of reach of children. Clean the appliance with a damp
cloth. Never touch the pole terminals of the accumulator!
Assembly and first start-up
Caution: The accumulator is supplied partially charged.
To ensure full power of the accumulator, charge it to the
full extent before first start-up.
This side up
Protective measure(s)
stray current
Safety switch against FI
stray current
The Li-Ion accumulator can be charged anytime without its
service life being reduced as a result. Charging interruption
does not damage the accumulator.
The Li-Ion accumulator has electronic protection against
deep discharge.
Due to the safety switch, the electric appliance switches off
when the accumulator is discharged:
The inserted tool is no longer moving.
After the electric appliance is switched off, do not press the
on/off button anymore.
If you do not use the accumulator, we recommend
charging it to the full extent at least once in 6 months.
The appliance must not be stored or used at temperatures
exceeding 40 °C as it reduces the accumulator life.
Montage
•
Screw the guide handle (3) to the appliance (B)
• The handle must be spread out carefully to snap in.
•
The guide handle locking must point to the left on the
knife side (B)
•
Pull the guide handle screw through the handle end
and screw it tightly while the locking is released (9).
•
The guide handle can now be secured and fixed in
several positions by locking.
• Using both screws (13), screw the hand guard to (D)
Make sure it runs in the guide grooves (C a).
Initial operation
Make sure the knife cover is fitted, which prevents
cutting injuries!
•
Compare the voltage of your network with that of the
charger. If corresponding, plug the charger.
• Plug the charging cable into appropriate accumulator
(accumulator needs 3-5 hours depending on its level
of depletion)
•
Insert the accumulator (F) until it snaps in. The lock
button needs to be pressed to be released (G 11).
•
The hedge trimmer can now be operated.
•
To start the hedge trimmer, you must first press the
switching bar and then the switch-on button.
Maintenance and cleaning
Take out the accumulator for cleaning, maintenance
and transport purposes!
There is a risk of injury associated with unintentional
pressing the on/off button.
Keep the electric appliance and any ventilation slot
clean to ensure good and safe operation.
If the accumulator does not work anymore, please contact
our customer service department.
Spare parts (optional)
Spare accumulator #95512
Service
Any technical questions? Complaint? Do you need
spare parts or operation manual?
Go to our website www.guede.com and the section
Service will help you quickly and without bureaucracy.
Please, help us to help you. In order to identify your device
in case of complaint, please indicate serial number, order
number and year of manufacture. All information is
available on the product label. To have all information
always at hand, put them down.
Serial number:
Order number:
Year of manufacture:
Phone: +49 (0) 79 04 / 700-360
Fax: +49 (0) 79 04 / 700-51999
E-Mail: support@ts.guede.com
12