Mounting The Cooker Hood - Pelgrim MSL600 Mode D'emploi

installation
24

Mounting the cooker hood

MSL600/SLK600/SLK680/SLK980
Drill 4 holes in the bottom of the wall cupboard,
using the stencil provided (H). Also saw the hole
for the duct.
H
Using the 4 screws supplied, fix the cooker
hood to the bottom of the cupboard. Make
G
sure that the front of the cooker hood does not
stick out in front of the side of the cupboard (G).
SLK650
Drill 2 holes (A) in the sides of the cabinet. Also
saw the hole for the duct. Insert the cooker
hood into the cabinet until the two retaining
springs (A) are fixed into the previously drilled
holes.
From the inside of the hood insert four screws
A
(B) supplied with the hood. If the sides of the
cabinet are thicker than 18 mm and the cooker
hood can not be installed due to the plastic
B
spacers (B), please remove the spacers.
The handle may be replaced by other material,
e.g. the same material used for the kitchen
A
cupboards or the light strip. The handle is
P
fitted from the back with screws.
Connect the cooker hood outlet flange (P) to
the duct (A). Put the plug in the wall socket.