EUROM ALUTHERM VERRE Wifi Manuel D'utilisation page 57

 Now switch the heater on using the ON/OFF switch. The screen will show P and
OFF to indicate that a setting has been programmed but that the heater is
currently off. At the set time, it will switch on and off automatically.
 The set timer details will be retained after it is switched off using the main
switch or plug.
 If you press repeatedly on WEEK, you will see the following timer settings, one
after the other:
One-off or repeated
-
Thermostat setting
-
Timer on-time
-
Timer off-time
-
Next timer setting
-
 If you would like to delete a specific setting, press and hold WEEK and then
search for the timer setting that you need. Go past 01- ][ and on/off first by
pressing SET briefly. When the number of the timer setting that you wish to
change appears, press SET for a little longer. You will hear a short beep and the
selected setting has been deleted.
 If you wish to delete all timer settings, press the WEEK button and hold. Press
and hold the MOD and SET buttons at the same time, until you hear a beep. The
screen will show 88:88, indicating that all settings have been deleted.
Please Note: all timer settings can only be deleted with the buttons on the
operating panel, not with the remote control!
 If you wish to retain the timer details but do not want to use the timer for a
while, push and hold the WEEK button and then push and hold the MOD until
TIME disappears from the screen to indicate that the data will be retained but
will not be active. By pressing MOD again until TIME appears, you will reactivate
the timer.
Screen protection: If the settings on a working heater are not adjusted for 2
minutes, the LED display will go out but ON will stay on. It will light up again when
you press a button. If the heather is switched off using the ON/OFF button, the OFF
screen will stay on.
57