EUROM ALUTHERM VERRE Wifi Manuel D'utilisation page 54

Secure the 2 hanging brackets o the wall. Choose a left and a right bracket and

secure them with the channel to the top, the short sides against the wall (see
diagram). Drill 2 holes in the wall, with a distance of 662 mm (1000) / 807 mm
(1500) / 970 mm (2000) between them, at least 60 cm. above the floor and
horizontal. Push plugs into the drilled holes and screw the brackets to the wall
using the 2 large screws.
Screw the other 2 brackets with the smaller screws below the heater, in the

relevant holes (see diagram): screw through the long side of the bracket, the short
side facing down. The short side will come to lie against the wall.
Hang the heater on both brackets and let it drop into the channels.

The short sides of the other 2 brackets will fall against the wall. Mark where these

must be screwed to the wall and lift the heater out of the brackets.
Drill 2 holes at the marked locations and insert plugs.

Hang the heater back on the brackets, let it drop into the channels and screw the

last 2 large screws through the lower brackets against the wall.
Check to ensure your heater is horizontal and secure, with the minimum distance

to the floor, ceiling and any side walls.
Freestanding
Attach the feet supplied to the underside of the heater (see picture):
Turn the heater upside down. Place a blanket (or something similar) under the heater to

prevent damage!
Place the feet on their place on the bottom of the heater. This will ensure that the

threaded holes will align correctly.
Securely attach the feet to the heater using the (2x2) self-tapping screws.

54