EUROM ALUTHERM VERRE Wifi Manuel D'utilisation page 55

Return the heater to the upright position.

Make sure a working heater is always placed on a solid, flat and horizontal surface.

Deep-pile carpeting is unsuitable!
Using for the first time and operation
 Check to make sure the main switch is set to O (off).
 Check that the heater is stable and upright, in line with instructions.
 Now insert the plug into the 220/240V socket.
 Set the main switch to I (on). The display will show: OFF
External temperature sensor
Because the temperature sensor is
located on the heater, it does not
measure the external temperature
very accurately. If you want accurate
measuring, connect the separate
thermostat (included in the delivery)
by inserting the small plug into the
control panel and placing the sensor
approx. 2 metres away from the
heater (see illustration). For this
purpose, you should remove the
heater from the wall and subsequently,
place it back. When you have
connected the separate thermostat, it
automatically takes over the thermostat operation.
Using the operating panel:
The operating panel (3) has 6 buttons:
MOD / SET / WEEK / + / - / ON-OFF
 Press the ON/OFF button in order to switch the heater on. The display lights up
and the heater can be operated.
 Now, set the day and time. Press and hold SET until SET appears on the screen.
The numbers of the weekdays (line 4) will blink. Use the + and – buttons to find
the right day (1 – Monday, 2 = Tuesday, etc.) and confirm with SET. The hour
will now blink. Use the + and – buttons to set the right hour and confirm with
SET. The minutes will now blink. Use the + and – buttons to set the right
minutes and confirm with SET. The day and time are now set.
Please Note:
The day and time settings will be lost if the heater is switched off using the
o
main switch or plug; these will be retained if the ON/OFF button is used.
If you do not set a time and day, the heater will assume that it is day 1 and
o
00.00.
55