EUROM ALUTHERM VERRE Wifi Manuel D'utilisation page 56

The screen goes off automatically after 2 minutes and can be turned on again
o
with any button.
 Press MOD to set whether you wish to work with the M or P function.
Under the M-function, you use the + and – buttons (remote control: with the bar
button) to set the capacity at which the heater will work: low, medium or high -
see technical details. The thermostat cannot be adjusted.
 Under the P-function, you can use the + and – buttons to set the desired
temperature for the heater, which it will then try to maintain. The heater will
automatically select the correct capacity: 1 or 2 degrees of heat = low, 3, 4 or 5
degrees of heat is medium and 6 or more degrees of heat is high. Once the
desired temperature is reached, the heater automatically turns off, and then
back on again when it cools down.
 Under the P-function, you can also set the weekly timer. Pressing WEEK, allows
you to set or check the weekly timer. Please note! To set the weekly timer, you
must first enter the day and time correctly.
Setting weekly timer:
 Press the WEEK button and hold it in. A blinking '01' will now appear on the
display. Use the + and – buttons to choose "01" (one-off setting) or "][" (the
setting your install will be implemented every week). Confirm with SET.
Note: the setting(s) that you enter under 'one-off' (01) must fall into the current
week. On Sunday (day 7) at 24.00, all one-off settings will be turned to non-active.
A setting that you enter on Tuesday for Saturday will work, but a setting that you
enter on Saturday for Tuesday will not.
Note: a one-off setting (01) will only be implemented by the heater once, but the
timer setting will stay as non-active in the memory and therefore takes the place of
one of the four possible settings on that day. You are better off deleting it, see
later.
Please Note: The choice of 'one-off' or 'repeated' now applies to all timer settings!
 "01 SET ON" appears on the screen to signify that you can set the first 'on' time.
You can now use the + and – buttons to select the day of the week for the
setting. Press SET for the right day.
 The temperature (standard 25°) now appears on the display and blinks. Use the
+ and – buttons to adjust it, from 0 to 37°C. Confirm with SET.
 The hour will now blink. Choose the right hour and confirm with SET.
 The minutes will now blink. Choose the right minutes and confirm with SET. The
first activation time is now set.
 Now, "01 SET OFF" will appear on the display, to indicate that you must set the
deactivation time. Do this in the same way as set out in the above 2 points. Your
first setting is now entered.
A '02' will now appear on the display. You can now set a second
activation/deactivation time; a total of 4 per day and 28 per week. If you don't
need to, wait until the screen returns to the standard settings.
Attention! All timer settings (maximum 28 per week) will be processed completely
one by one. Therefore, make sure that they do not contradict each other!
56