Joystick Controller Position; Swing-In/Out Footrest Adjustment; M.angle Adjustable Center Mount Footrest - Zippie ZM-310 Mode D'emploi

Z I PP I E Z M- 3 10
K. JOYSTICK CONTROLLER POSITION
The controller can be moved in or out in relation to the armrest. You can also move the
controller to either side of your chair to accomodate left or right-hand use.
Be careful of pinching the controller cords. When the controller is moved, the harness and
cord can be at risk of pinching from the Seat frame, and/or the Power base frame. Be sure
to route and secure the cord with a zip tie to avoid cord pinching,. Cord pinching could
eventually disable your power chair if left unchecked.
Before Moving the controller from one side to the other read these important tips.
a. Turn off the power to the controller.
b. Unplug the controller connectors from the power base.
c. Remove any wire ties securing the controller harness to the armrest.
d. Flip up the armrest so that it is perpendicular to the floor.
e. Loosen the hardware on the controller bracket and slide the controller out.
f. Re-tighten the hardware, so it won't be lost accidentally.
g. Loosen the hardware on the other armrest.
h Slide the controller arm into the other armrest, and tighten the hardware.
i. Route and secure the controller harness to the back of the power base and plug in
the controller cord. Make sure to avoid any areas where the cord may be pinched.
Adjustment and/or switch sides.
a. To adjust the joystick, forward or back, loosen the clamp(A), move the joystick, and
then hand-tighten the clamp handle.
b. To move the joystick to the opposite side of the chair, remove the hardware(B) and
move the clamp and joystick receiver to the other armrest.
c. Tighten all hardware to avoid any movement of the joystick while travelling.
L. SWING-IN/OUT FOOTREST ADJUSTMENT
Footplate Height Adjustment
a. Remove the hardware(C) from the hanger frame tube.
b. Move the footrest extension tube(D) up or down to set the correct height, and line
up the adjusted holes.
c. Insert the hardware to hold the tube in place.
d. Re-tighten all hardware(C)
M. ANGLE ADJUSTABLE CENTER MOUNT FOOTREST
(ASAP Seating only)
1. Quick Independent angle adjustment
a. Depress the button(E) and angle adjust the footplates as an assembly
b. The footplates can be moved independantly of each other by removing the bracket
(G) that locks the footplates together.
2. Footplate Height Adjustment
a. Loosen the securing screws (F).
b. You can move the footplates up or down to the desired height as an assembly or
adjust the height for each footplate independantly
c. Tighten the hardware(F)
64
WARNING
65
31
XI. DEALER SERVICE & ADJUSTMENT
66
64
B
A
65
66
127899 Rev. B