H.cantilever Armrests; Retractable Joystick Mount; Midline Joystick Mount - Zippie ZM-310 Mode D'emploi

Masquer les pouces Voir aussi pour ZM-310:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Z I PP I E Z M- 3 10
H. CANTILEVER ARMRESTS (Optional)
1. Adjusting Armrest Pad (forwards or backwards)
a. Loosen the 2 bolts (A) on the armrest pad bracket.
b. You can move the armrest and receiver forwards or backwards for a universal fit.
c. Tighten the hardware when adjustment is complete.
2. Adjusting Armrest Angle or levelling the armrest after height adustment.
a. Loosen the pivot bolt (B) on the armrest angle bracket.
b. Remove the Socket head screw and hardware. (C)
c. Adjust the angle of the armrest and joystick and re-insert the hardware thru the
adjusted hole.
d. Tighten all hardware when adjustments are complete.
3. Adjusting Armrest Height (within factory limits)
a. Locate the height adjustment screw (F) at the bottom of the cantilever arm and adjust
the height by using a 5mm hex key and turning the screw either clockwise (more
height), or counter-clockwise (less height).
b. Do not loosen the screw to the point where it will fall out of the armrest. If this hap-
pens simply re-thread the screw into the armrest until it starts to height adjust the
armrest again.
c. When you reach desired height remember to level the armrest using screws (D) and
(E) as shown in step 2 above.
NOTE - The cantilever armrest has about 2" of adjustment set from the factory. In most cases the
external height adjustment will be all that is necessary for a proper fit
I. RETRACTABLE JOYSTICK MOUNT
The Retractable Joystick Mount can swing in/out in increments of 45°, 90°, and 135°
1. Height adjustment
a. Remove the Joystick mount (G) by removing hardware (H).
b. Flip bracket ( I ) upside down and re-attach the Joystick mount assembly components
c. Replace and retighten bolts on each side.
J. MIDLINE JOYSTICK MOUNT
The Midline Joystick Mount has 3 axis adjustment, and can be rotated out of the way.
1. Left, Right, Center adjustment
a. Loosen the clamp screws ( J ) and move the joystick laterally in front of the rider.
b. After finding the most comfortable adjustment, make sure the Joystick is level.
c. Retighten the clamp screws.
2. Height adjustment
a. Loosen the clamp screw (K) and move the joystick vertically,
b. After finding the most comfortable adjustment, retighten the clamp screw.
127899 Rev. B
60
61
62
63
30
XI. DEALER SERVICE & ADJUSTMENT
B
F
60
A
C
61
E
D
62
63

Publicité

Table des Matières
loading

Table des Matières