Q Motor Lock; Battery Removal; Check Out - Zippie ZM-310 Mode D'emploi

Z I PP I E Z M- 3 10
Q. MOTOR LOCK
18
Disengage the Motor Lock when you need to manually push the chair. (For example, in an
emergency, or if batteries fail).
1. Do not disengage Motor Lock unless chair power is off.
2. With either one or both locks released, the chair will not operate and the battery
charge indicator will flash 9 bars rapidly (if power to the chair is on.)
3. Be aware that the chair will not have brakes in the free-wheel position.
4. Make sure that the person pushing the chair has full control when Motor Lock
lever is disengaged.
1. Disengage the Motor Lock to push the chair manually
a. The Motor Lock lever (A) is attached to the rear section of the motors located
towards the back of the chair.
b. Push the Motor Lock lever down to disengage.
2. Engage the Motor Lock to drive the chair
a. The Motor Lock (A) is attached to the upper rear section of the motors located at
the back of the chair.
b. Pull the lever up to engage the Motor Lock.
R. BATTERY REMOVAL
1. To remove the batteries before transporting or servicing:
a. Carefully flip back the seat (see Section XI Q. "Seat removal")
b. Remove the shroud (see Section XI E. "Shroud removal") .
c. Unplug the main power connect (B) (Fig. 19)
d. Lift the batteries out of the frame using the battery strap as a lifting handle.
2. Battery installation
• See section X. (Batteries) for installation
Batteries may weigh up to 55 lbs. Care must be taken to avoid injury when lifting up on
battery straps.
S. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All
accessories should the checked to make sure they are also performing smoothly. After
the wheelchair has been set-up, be sure that the chair performs to ytour specified opera-
tional settings.
If the chair does not perform the way you expect it to, (according to specifications), turn
your wheelchair OFF immediately and contact your authorized supplier to re-program
operational settings using the RNET operating guide.
If you have any problems, follow this Procedure:
a. Review the Set-up, Adjustment, and use section and the Operating Guide to make
sure the chair was properly prepared.
b. If your problem persists, contact your authorized supplier. If you still have a prob-
lem after contacting your authorized supplier, contact Sunrise Medical Customer
service. See the introduction page for details of how to contact the people who
can help you.
WARNING
19
WARNING
19
VIII. USE & MAINTENANCE
HEADER
A
B
18
19
127899 Rev. B