U.joystick Controller Position; Check Out - Zippie ZM-310 Mode D'emploi

Masquer les pouces Voir aussi pour ZM-310:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Z I PP IE Z M- 310
T. JOYSTICK CONTROLLER POSITION
You can move the controller in or out in relation to the armrest. You can also move the
controller to either side of your chair to accomodate left or right-hand use.
Be careful of pinching your controller cords. When the controller is moved, the harness
and cord can be at risk of pinching from the Seat frame, and/or the Power base frame. Be
sure to route and secure the cord with a zip tie to avoid cord pinching,. Cord pinching
could eventually disable your power chair if left unchecked.
Before Moving the controller from one side to the other read these important tips.
a. Turn off the power to the controller.
b. Unplug the controller connectors from the power base.
c. Remove any wire ties securing the controller harness to the armrest.
d. Flip up the armrest so that it is perpendicular to the floor.
e. Loosen the hardware on the controller bracket and slide the controller out.
f. Re-tighten the hardware, so it won't be lost accidentally.
g. Loosen the hardware on the other armrest.
h Slide the controller arm into the other armrest, and tighten the hardware.
i.
Route and secure the controller harness to the back of the power base and plug in
the controller cord. Make sure to avoid any areas where the cord may be pinched.
Adjustment and/or switch sides.
a. To adjust the joystick, forward or back, loosen the clamp(A), move the joystick, and
then hand-tighten the clamp handle.
b. To move the joystick to the opposite side of the chair, remove the hardware(B) and
move the clamp and joystick receiver to the other armrest.
c. Tighten all hardware to avoid any movement of the joystick while travelling.
U. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All acces-
sories should the checked to make sure they are also performing smoothly. After the wheel-
chair has been set-up, be sure that the chair performs to ytour specified operational settings.
If the chair does not perform the way you expect it to, (according to specifications), turn
your wheelchair OFF immediately and contact your authorized supplier to re-program oper-
ational settings using the RNET operating guide.
If you have any problems, follow this Procedure:
a. Review the Set-up, Adjustment, and use section and the Operating Guide to make sure
the chair was properly prepared.
b. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise Medical Customer service.
See the introduction page for details of how to contact the people who can help you.
22
WARNING
21
VIII. USE AND MAINTENANCE
22
B
A
127899 Rev. A

Publicité

Table des Matières
loading

Table des Matières