Machine Operation - Clarke CA90 32T Mode D'emploi

MACHINE OPERATION

WARNING !
Do not operate machine unless you have read and understand this manual.
1. Before the machine will operate, the key switch must be turned into the "on" position. The key is located on the left side of the control housing.
(see machine components, item #19)
2. Set control housing to a comfortable operating height by squeezing together the tow thumb levers directly underneath the housing (see
machine components item #16)
3. Lower squeegee assembly to the fl oor. There is a squeegee lift handle located on the back left of the machine, just under the control housing.
(see machine components, item #14) Slightly lift up on the handle and move it to the right, the squeegee is now ready to be lowered to the
fl oor.
4. Lower the brush head to the fl oor by pushing the brush lower button on the control housing. (see machine components, item #7)
5. Turn vacuum motor switch to "on" position. (see machine components, item #1)
6. Turn the brush motor switch to "on" position. (see machine components, item #2)
a. Brushes will not spin until the operating triggers are pulled.
7. Turn the solution switch to "on" position. (see machine components, item #3)
a. Solution will not begin to fl ow until the operating triggers are pulled.
8. To begin scrubbing, pull on one or both of the red operating triggers. (see machine components, item #27) When the triggers are pulled, the
brushes will begin to spin, the solution will begin to fl ow, and the machine will propel itself.
9. This machine is self-propelled. The speed can be adjusted by a dial located on the right side of the control housing. (see machine
components, item #9)
10. This machine has reverse. In order to activate reverse, there is a toggle switch on the left side of the control housing. (see machine
components, item #20) The toggle switch must be pulled / pressed to activate reverse motion.
HINT:
Do not keep the machine in the same position with the pad / brush spinning, or you could cause damage to the fl oor.
11. Adjust the amount of solution fl ow by turning the solution control knob. Turn the knob to the right for more solution, or turn left for less
solution. (see machine components, item #8)
12. There is an hour meter located on the top of the control housing. (see machine components, item #4) The operator can see the operation
time.
7/2014
INSTRUCTIONS FOR USE
56091127 - CA90 32T
ENGLISH - A
A - 5