Starting The Tac3 Dfe Control; General Schematic; Connecting The Remote Control To The Cbr - aldes DFE Série Manuel D'installation Et De Maintenance

3.3 Starting the TAC3 DFE control

The control is delivered assembled and factory wired. Only the RC (Remote Control) must be installed where
chosen and wired by a qualified installer.
The DFE control consists of 2 parts (see 3.1):
•
A CBr4 TAC3 REC circuit which is factory assembled, wired and tested in the unit. Connections are to be made
by the installer to this part.
•
A remote control RC TAC3 REC which must be properly wired by the installer to the CBr circuit. This component
allows full configuration of the unit, display of all the parameters as well as the control of the fans.
3.3.1 General schematic of the DFE control device:
3.3.2 Connecting the remote control to the CBr circuit
The connection between the various modules is made by a communication bus. Once you know where to install the
RC follow these steps to connect the RC to the CBr:
3.3.2.1 Open the RC casing:
Using a small screwdriver unlock the 4 pins
2 pins on each side
35