Installation Instructions; How To Assemble The Roof (Option) - aldes DFE Série Manuel D'installation Et De Maintenance

II. INSTALLATION instructions
2.1. How to assemble the roof (VEX option)
The roof (VEX) option is delivered unassembled for transportation reasons. Please follow these instructions to
assemble the different parts:
a) Remove the plastic film from the top part of the DFE unit. Make a silicone seal (not supplied) between the panels
and between the aluminium profiles on the top part of the unit, as shown on the picture a)
b) Place the different elements of the roof on top of the unit, over the silicone seals. Make sure you leave following
distance on each side of the unit so as to cover the whole unit properly:
Unit type Distance on the "left" and 'right" sides
DFE 450
DFE 600
DFE 800
DFE 1200
c) Use the supplied M8 screws to screw the roof onto the DFE unit. The screws must be screwed into the aluminum
profile and properly aligned. Use a pen to point the location of the screw. Mount the plastic caps supplied over the
screw heads.
d) Insert silicone inside the U-clip used to join the different roof parts and place the clip over the roof sections as
shown on picture d1 and d2.
e) Make a silicone seal between the aluminium profile and the roof all around the unit, as shown in picture e).
75 mm
75 mm
75 mm
71 mm
a)
c)
Distance on the « in » and « out » sides
100 mm
100 mm
70 mm
102 mm
b)
d1)
31