Advanced Setup - aldes DFE Série Manuel D'installation Et De Maintenance

Wiring diagram of output signals:
CBr
Default: OUT1 = actual airflow of fan 1 (supply)
CBr
Default: OUT2 = actual pressure of fan 1 (supply)

4.7 Advanced setup

Warning: using this feature requires a good knowledge of the DFE control system.
The advanced configuration allows modifying the parameters not present in the basic configuration:
- Stop fans is pressure alarm activated
- Fans start torque
- Fire alarm configuration
- Bypass T°
- Airflow if bypass open
- AF (anti-freeze) configuration
- In mode LS: stop of the fans if Vin < and/or > set value(s)
- In mode CPs: - positive or negative logical
- reaction speed of the CPs algorithm
- OUT1/OUT2 definition
- Post-ventilation configuration
- Fan run time configuration
- Display alarms only
- Access code configuration
- Factory
50
reset