M.folding Backrest; N.check-Out - Quickie Freestyle M11 Mode D'emploi Et Garantie

I X . S e t - U p , A d j u s t m e n t & U s e
M. FOLDING BACKREST (Seat Frame)
(Figure 22)
Folding backrests are shipped with backrest in folded position.
1. Upright Positioning
a. Lift backrest to upright position so that latch handles (C) lock into place.
b. Backrest is ready for use.
2. Folding Backrest
a. Lift and turn backrest latch handles (C) inward or outward.
b. Fold backrest forward.
N. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All
accessories should also perform smoothly.
After the wheelchair has been set up be sure the chair performs to your specified operational
settings (see Operating Guide). If the chair does not perform to specifications, turn the
wheelchair OFF immediately and reprogram operational specifications using the QTRONIX
Programming Pad.
Repeat this procedure until the wheelchair performs to specifications before attempt-
ing active use of the wheelchair.
If you have any problems, follow these procedures:
1. Review the Set-up, Adjustment & Use section and Operating Guide to make sure chair
was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
E n g l i s h
22
C
25
930583 Rev. F