Quickie Neon2 Manuel D'utilisation page 34

Pelvic Restraint Belt (continued)
When fastened check space between the lap belt and user. When
correctly adjusted it should not be possible to insert more than the
flat of the hand between the pelvic restraint belt and the user, (Fig.
6.15.7).
The lap belt should be fxed so that the belt sits at an angle of 45
degrees across the users pelvis. The user should be upright and be
as far back as possible in the seat when correctly adjusted. The pelvic
restraint belt should not allow the user to slip down in the seat,.(Fig.
6.15.8).
To fasten buckle:
Firmly push male buckle into female buckle, (Fig. 6.15.9).
To release buckle:
Press the RED button in the centre of the buckle then pull the two
halves gently apart, (Fig. 6.15.10).
NOTE: If you have any questions on the use and operation of the
pelvic restraint belt, the please contact your wheelchair dealer, carer
or attendant.
WARNINGS!
• The pelvic restraint belt must only be fitted or adjusted by an
approved Sunrise Medical dealer / agent.
• The lap belt must be checked on a daily basis to ensure it is
adjusted correctly and it is free from any obstruction or adverse
wear.
• Sunrise Medical does not recommend the transportation of a
person in a vehicle with the pelvic restraint belt as a restraint
system.
See the transit brochure from Sunrise Medical for further
information on transportation.
Maintenance:
Check lap belt and securing components at regular intervals for any
sign of fraying or damage. Depending on usage, it may need to be
replaced.
WARNING!
The pelvic restraint belt should be adjusted to suit the end user as
detailed above. Sunrise Medical also recommends that the length and
fit of the belt is checked on a regular basis to reduce the risk of the
end user inadvertently re-adjusting the belt to an excessive length.
NEON 2 SA
Fig. 6.15.7
Fig. 6.15.8
Fig. 6.15.9
Fig.6.15.10
34
Rev.B