Configuration Of The Dante Network; Installing The "Dante Controller - Monacor AKB-30DT/DSP Mode D'emploi

5 Configuration of the Dante Network

The AKB-30DT/ DSP is configured as a receiver in the Dante network
by means of the program "Dante Controller", available as a free
download on the website of the company Audinate . The settings made
via the program will be saved in the corresponding transmitters and
receivers of the Dante network so that the program is only required
for network configuration but not for normal operation . The following
system requirements apply to the computer on which the program
"Dante Controller" is to be executed:
Component
Processor 1 GHz
RAM 512 MBytes
Standard Ethernet interface (100 Mbits / s or Gigabit) or
Network
wireless LAN (WiFi) interface
Windows 7 (SP1 or higher), 8.1 or 10
Note: Both UTF-8 and Unicode will be supported, except for host names
and names of units; the DNS standard will not support Unicode for them.
Operating system
Mac OS X 10.9.5, 10.10.5 or 10.11
Note: Intel architecture only; PPC architecture will not be supported.
Fig. 2 System requirements for "Dante Controller"
Windows is a registered trademark of Microsoft Corporation in the USA and other
countries. Mac OS is a registered trademark of Apple Inc. in the USA and other
countries.
Minimum requirements

5.1 Installing the "Dante Controller"

To install the program from the Audinate website:
1) Call up the following Internet address:
https://www .audinate .com/products/software/dante-controller
2) Select the operating system .
3) Click the button with the version of the Dante controller .
4) Log in or create an account .
5) Download the software .
6) Install the software .
37