Creating A New Program Password; Changing The Program Password; Demo Mode; Firmware Update - Monacor AKB-30DT/DSP Mode D'emploi

7.2.2 Creating a new program password

To create a password protection for starting the program:
1) Call up the menu item "Tools Set Software Password" .
2) Enter the desired password in the field "Enter New Password:" of
the window displayed .
3) Another window will appear: To confirm, enter the password once
again in the field "Confirm New Password:" and make sure to
remember it!

7.2.3 Changing the program password

To change the password for starting the program:
1) Call up the menu item "Tools Change Software Password" .
2) Enter the current password in the field "Enter Old Password:" of
the window displayed .
3) Another window will appear: Enter the new password in the field
"Enter New Password:" .
4) Another window will appear: To confirm, enter the password once
again in the field "Confirm New Password:" and make sure to
remember it!

7.2.4 Demo mode

If no unit is connected to the computer, it is possible to create a virtual
unit for demonstration purposes . For this purpose, call up the menu
item "Tools Enter Demo Mode" .
A list will appear, showing various virtual units with the addition
"DEMO..." . Just like for real units, the button
the configuration menu (
To delete the virtual units from the list, call up the menu item
"Tools Leave Demo Mode" .
44
is used to call up
☞ fig . 9) .

7.2.5 Firmware update

The control program and the unit must be equipped with matching
firmware versions to ensure smooth communication . If the control
program is a later version, it is possible to update the firmware (oper-
ating system) of the units via the control program . After an update,
all settings saved on the units will be lost . To keep the settings, save
them on the computer before starting the update (
and 7 .10) .
Note: Firmware updates are made at your own risk . After an update, the func-
tions of the unit may differ from the functions described in the instruction
manual .
CAUTION: Switch off the signal sources or reduce their output levels
to prevent unexpected high volumes after resetting .
To update the firmware of a unit, call up the menu item "Tools Enable
Update" . An icon will appear after the units in the list . When the
icon is grey, an update is not possible (e . g . because the firmware of
the unit has already been updated or because the access rights do not
permit an update) . When the icon is orange, an update is possible:
1) Click the button in the line of the desired unit .
2) A message will appear warning the user not to switch off the unit
during the multi-step update process or not to disconnect the
connection . If the update fails, start it once again .
Start the update with [OK] or cancel it with [Cancel] .
3) When the update has been successful, another message will appear .
Confirm this message as well .
To hide the update icons in the list, call up the menu item "Tools
Disable Update" .
☞
chapters 7 .8