Update Via The Menu Of The Configuration Window; Exiting The Program - Monacor AKB-30DT/DSP Mode D'emploi

Note: A reset to the factory settings will also affect the network settings and
the passwords of the unit, i . e . for the time being, it may be impossible
to access the unit from the computer (compare note in chapter 7 .2 .5 .1) .

7.2.5.1 Update via the menu of the configuration window

It is also possible to update the firmware via the menu of the con-
figuration window (Hardware Firmware Update) if the unit is at the
access level "Administrator" or if it is at the access level "User" and
the corresponding access right "Upgrade the unit firmware" has been
granted to the "User" level (
At the administrator level, manual selection of the firmware is also
possible . To open the File Explorer, go to "File Load Factory Settings"
in the menu of the configuration window . A flash image file (exten-
sion " .ffi") does not only contain the presets and the corresponding
settings and access options; it also contains the complete firmware .
Note for loading a flash image file (*.ffi): When a flash image is loaded, a
firmware update will be made and then a factory file will be loaded .
A firmware update will reset the unit to automatic IP address assignment
("Network Settings" ☞ chapter 7 .11) . Therefore, the computer may no longer
be able to access a unit that was previously set to a fixed IP address . As a result
of this disconnection, the flash image file may not be loaded completely .
Important: Before loading a flash image file, make sure that an IP address has
automatically been assigned both to the PC network interface and to the unit .
☞ chapter 7 .4 .3) .

7.2.6 Exiting the program

To exit the program, call up the menu item "File Quit" or close the
program window .
45