Operation; Access Levels; Before Operation - Monacor AKB-30DT/DSP Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6 Operation

The amplifier does not feature any control elements . Its signal pro-
cessor (DSP) is exclusively operated by remote control via the network
from a computer (
computer and restricted control of unit groups via smartphone is
possible (
 chapter 9) .
In any case, please note that the range of available functions
depends on the access rights of the user . These rights are defined
in access levels (
 chapter 6 .1) to be configured according to your
requirements .

6.1 Access levels

If it is not possible to execute all operating steps described in the
manual, this may be due to restricted access rights .
For configuration, three access levels with different rights are
available . The levels "Administrator" and "User" are accessed via
different passwords .
The following table shows the access levels in descending order and
the corresponding passwords:
Access level
Administrator
User
Locked State
Fig. 5 Default passwords
* The passwords are factory-set and can be changed by the user at the corre-
sponding access level . Make sure to remember the password after changing it!
40
 chapter 7) . In addition, operation via tablet
Password *
mega_adm
monacor
The passwords are saved in the amplifier . When the amplifier is
switched on, it is always at the level "User" . To change the level dur-
ing operation, enter the corresponding password via the menu item
"Hardware Enter Password" of the control program (
7 .4 .1) or call up the "Locked State" via the menu item "Hardware
Lock Unit" (
 chapter 7 .5) .
At the access level "Administrator", the control options of lower
levels can be restricted (
 chapter 7 .4 .3) .

6.2 Before operation

If you do not know the start settings of the amplifier after switching on
the power supply, set the audio sources at the Dante network to a low
volume . This will prevent undesired high volumes after switching on .
After switching on the power supply, the amplifier will load the previous
settings or a specific preset defined for this purpose (
 chapter
 chapter 7 .7) .

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

17.6770

Table des Matières