Anselmo Cola TERMO FOCUS PLUS Manuel D'installation, D'utilisation Et D'entretien page 51

4.6.1 Menu 01 – adjust fans
The item of menu 01, if enabled, adjusts the speed of the supplementary fans (not available).
4.6.2 Menu 02 – set clock
Before operating with the stove it is necessary to set the current time and date so that there is a reference for possible
chrono programming.
The electronic control device has a lithium battery mod. CR2032 of 3 Volt inside. It allows the internal clock with own
autonomy; if the clock signal does not appear when the stove is off or when switching the stove again a series of
"0000" appears, it means it has to be substituted and you need to call one of our service point authorised for its
substitution.
4.6.3 Menu 03 – enable chrono
Allows all chronothermostat functions to be enabled/disabled.
Regarding the selection and entering of times, use the six buttons,
following the table in par. 4.2.
It allows to enable and disable all the thermostat functions programmed;
with the set ON you activate this function and it appears the led
[ D ] related to it.
When the daily, weekly, or week-end program is set you can see on
the upper right side of the display it appears the led [C].
By accessing the submenu:
chronothermostat functions can be enabled/disabled and set.
It is possible to set two operation phases delimited by the times set
according to the following table where the OFF setting tells the
clock to ignore the command.
Selection
Activation time
Deactivation time
Activation time
Deactivation time
By accessing the submenu: WEEK PROGRAM it is possible to
enable/disable and set the weekly chronothermostat functions.
The weekly programmer has 4 independent programmes whose
final effect consists of a combination of the 4 programmings.
The weekly programmer can be activated/deactivated; also, by
setting OFF in the times field, the clock ignores the corresponding
command.
Carry out programming making sure not to overlap the
hours of activation and/or deactivation on the same day in
different programmes.
DAY PROGRAM,
Meaning
the daily
Possible values
51
C
D
Menu level
Input
Dialogue box
Menu level
Dialogue box
TERMO FOCUS PLUS acciaio
B
A