The Remote Control; Delayed Switch Off Enabling; Type And Replacement Of Batteries; Commissioning Settings - Dal Zotto INSERTO 700 2.0 Manuel Utilisateur

THE REMOTE CONTROL

All that can normally be implemented through the LCD can be adjusted using the remote control.
The table below provides a detailed description of the various functions:
1
2
6
3 7
9
8
11 12
INFO
14
15
Important note: the numbers shown on the remote control are purely indicative and are not present on the remote control supplied with the product.

TYPE AND REPLACEMENT OF BATTERIES

The batteries are housed in the lower part of the remote control.
To replace them, remove the battery holder (as indicated in the gure at the back of the
remote control), remove or insert the battery following symbols on the remote control and
on the battery.
For operation, 1 CR2025, 3V lithium bu er battery is required.
If the remote control is o because it has no batteries, the stove can be controlled from the control panel on top of it.
While replacing the battery, pay attention to the polarity by observing the symbol on the inside compartment of the remote
control.
The batteries used contain metals harmful for the environment. They must therefore be disposed of separately in appropriate
containers.

COMMISSIONING SETTINGS

Once the power cable at the back of the stove has been connected, move the switch, also located on the back, to (I).
The switch at the back of the stove powers the stove board.
The stove remains o and a rst screen appears on the panel reading OFF.
1 ON / OFF
2 POWER INCREASE
3 POWER DECREASE
4 T° INCREASE
5 T° DECREASE
ENABLE / DISABLE
6
CHRONO
4
DELAYED SWITCH OFF
7
ENABLING
5
8 MENU
9 INCREASE
10
10 ESC KEY
11 BACK
13
12 CONFIRMATION KEY
13 FORWARD
16
14 ENABLE FUNCTION F1
15 DECREASE
16 STOVE STATUS
Pressing the key for three seconds, the stove will switch on or o
Pressing the key will increase the operating power
Pressing the key will decrease the operating power
The temperature setting can be increased by pressing this key
The set temperature can be decreased by pressing this key
Pressing the key once will enable or disable the chrono
The delayed switch-o can be set by pressing this key.
For example, if the stove is set to switch-o in an hour, it shall switch-o
automatically once the set time elapses, displaying the countdown every
minute for delayed automatic shutdown.
This key allows to access the user and technical menu (the technical
menu is reserved for assistance)
The temperature setting can be increased by pressing this key
The key allows the user to exit any program or display and returns to the
main menu without saving the data
The key returns to the display of the various menus
This key con rms the adjustments made during the user menu
programming phase
The key allows to go forward in the various menus
Pre-set key for future applications
The key decreases the value to be set
Pressing this key will display the general status of the stove
ENGLISH 53