If the Stby function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating and displaying
modulate. When the room temperature is below the setting, it will start to work again at the set power and displaying work.
STAND BY WITH ADDITIONAL THERMOSTAT
The STBY function is used if immediate stove switch-o is required when the set temperature has been reached.
By default the STBY function is always set on OFF (light
•
STBY FUNCTION SET AT OFF DEFAULT SETTING
If the STBY function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating and displaying
. When the room temperature is below the setting, it will start to work again at the set power and displaying
MODULATION
•
STBY FUNCTION SET AT ON
When the STBY function is activated (ON), the stove, upon reaching the set room temperature and exceeding it by 2°C, will switch o after
a pre-set default delay, displaying STAND - BY.
When the room temperature is 2°C lower than the setting, the stove will start to work again at the set power displaying WORK.
CONTROLS PROCEDURE
Press key 6 and SET CLOCK WILL APPEAR.
Press key 2 several times to reach SET USER.
Con rm using key 6.
Press key 2 several times to reach STAND BY.
Using key 4 or 5 select at ON.
Press key 6 to con rm and key 1 to return to the previous menus up to the
initial status.
The STAND BY function is active
KEYS LOCKED
The menu allows to lock the display keys (like with mobile phones).
With the function engaged, every time a key is pressed, "KEYS LOCKED" will appear.
CONTROLS PROCEDURE
Press key 6 and SET CLOCK will appear.
Press key 2 several times until USER is displayed.
Press key 6.
"DISPLAY" will appear.
Press key 2 until "KEYS LOCKED" appears.
Use keys 4 -5 to select enable/disable.
Press key 6 to con rm and key 1 to return to the previous menus up to the
initial status.
ONCE THE FUNCTION IS ACTIVATED, USE KEYS 1 AND 5 AT THE SAME TIME TO LOCK OR UNLOCK THE KEYBOARD
58
on).
ENGLISH
.
WORK