Assembly With Sliding Base; Pedestal Assembly Optional - Dal Zotto INSERTO 700 2.0 Manuel Utilisateur

ASSEMBLY WITH SLIDING BASE

Take the sliding base and position it in the pre-existing ue. Use chalk to mark the blocking holes of the base on the ue surface. Drill 8 mm
holes for the steel expansion inserts.
Make a hole measuring 60 mm in line with the air intake.
Remember the power socket on the rear of the insert so that the plug is accessible once installation is completed.
Fix the base using the clamping screws.
Create a ue exhaust and socket connection respecting the points described previously.
Take the insert, tilt it so that the wheels t into the relative rails, make it run until the ue gas insert is completely inserted into the ue gas
conveyor box.

PEDESTAL ASSEMBLY OPTIONAL :

Position the base in the desired point and use the feet to adjust the desired height (the bolts are positioned in the four external sides of the
pedestal in the lower part).
Remember the power socket on the rear of the pedestal so that the plug is accessible once installation is completed.
Fix the pedestal to the oor using strong steel plugs with a diameter of 8 mm.
Fix the sliding base to the frame using bolts.
Connect the ue gas exhaust pipe and the air vent as stated in the previous paragraph.
Take the insert, tilt it so that the wheels t into the relative rails, make it run until the ue gas auger is completely inserted into the ue gas
conveyor box.
Finally open the re door and use the supplied Allen key to turn the screw at the bottom left corner clockwise.
To understand whether the insert is correctly attached to the base, connect the plug to the socket and make sure the display switches on.
N.B.: If our pedestal is used, a slot must be created in the ue that allows
the pellet level in the feed-box to be checked, thus preventing spillage
during lling.
ENGLISH 47