Dal Zotto INSERTO 700 2.0 Manuel Utilisateur page 46

Make a hole at the base of the ue ( gure 1) for air circulation and to ensure the required combustion air for proper insert combustion.
If it is not possible to make a hole at the centre of the base, make two openings to the sides of the base, equal to the 550cm² overall lower inlet
(2 x 275cm²) (See gure 2).
Air inlet
Base
( gure 1)
In order for the insert to work properly, observe the measurements contained in the "MINIMUM DIMENSIONS" when building the chimney that
must be made of non- ammable material.
As well as the dimensions of the stove given in the technical features, consider at least 50 mm of air at the back of the insert. (see gure 3)
( gure 3)
To protect from any over-heating, the inserto 700 2.0 is supplied with a probe that analyses the temperature inside the structure and intervenes
by reducing the functioning power.
THIS VENTILATION SYSTEM IS TOTALLY INDEPENDENT FROM THE AIR INTAKE FOR COMBUSTION!!
46
Air inlet
275cm²
ENGLISH
Base
Air inlet
275cm²
( gure 2)
5 cm