Remote Control Optional; Type And Replacement Of Batteries; Commissioning Settings; Mains Frequency 50/ 60Hz - Dal Zotto EDY Manuel Utilisateur

REMOTE CONTROL OPTIONAL

The heating power, the desired room temperature and the appliance ignition/switch o , can be adjusted using the remote control.
To ignite the stove, press key 1 for a few seconds; the appliance will automatically enter the ignition phase. It is possible to adjust power by
using keys 4 and 5, whereas the desired temperature can be adjusted using keys 2 and 3. To switch the stove o , press and hold key 1 for a
few seconds.

TYPE AND REPLACEMENT OF BATTERIES

The batteries are housed in the lower part of the remote control.
To replace it remove the battery-holder (as shown in the gure
on the back of the remote control), remove or insert the battery
following the symbols on the remote control and on the battery.
If the remote control is o
batteries, the stove can be controlled from the
control panel on top of it.
While replacing the battery, pay attention to the
polarity by observing the symbol on the inside
compartment of the remote control.
THE BATTERIES USED CONTAIN METALS HARMFUL FOR THE ENVIRONMENT. THEY MUST THEREFORE BE DISPOSED OF
SEPARATELY IN APPROPRIATE CONTAINERS.

COMMISSIONING SETTINGS

Once the power cable at the back of the stove has been connected, move the switch, also located on the back, to (I).
The switch at the back of the stove powers the stove board.
The stove remains o and a rst screen appears on the panel
reading OFF.

MAINS FREQUENCY 50/ 60HZ

In the event the stove is installed in a country with 60Hz frequency, the stove will display "frequenza rete errata" ("mains frequency incorrect").
Vary the frequency as described below.
CONTROLS PROCEDURE
Š Press key 5.
Š Select 50 - 60Hz frequency with key 2 -3.
Š Con rm using key 5 and exit the menu by pressing key 1.
because it has no
For operation, 1 CR2025, 3V lithium bu er battery is required.
ENGLISH
1
4 3
2
5
43