Table Of Settings - Technische Alternative UVR 63 Mode D'emploi Et Instructions De Montage

Table of settings

If the control system fails unexpectedly, all of the settings should be reset for initial configuration.
In this case, problems are inevitable if all of the setting values are entered in the following table. If
there are questions, this table has to be provided. Only then is a simulation possible to reproduce
the error.
EX ......... factory settings (ex works)
Equipment version
Linking of output LO
max1 off 
max2 off 
max3 off 
min1 on 
min2 on 
min3 on 
diff1 on 
diff2 on 
diff3 on 
Subject to change without notice
CS .......... Controller settings
EX CS
Basic parameters PAR
Program PR
OFF Priority assignm. PA
°C max1 on 
°C max2 on 
°C max3 on 
°C min1 off 
°C min2 off 
°C min3 off 
K diff1 off 
K diff2 off 
K diff3 off 
English
EX CS
0
OFF
°C
°C
°C
°C
°C
°C
K
K
K
2016
35