Muller licht tint 404028 Mode D'emploi page 66

1. Plug the new tint product in at the mains and set the corresponding
light switch to I or ON.
The new tint product will signal that it is in coupling mode by briefly
increasing and decreasing its brightness and changing color if
applicable. If this does not occur, switch the product off and on again
5 times (see „Resetting the tint product")
2. Press the group button repeatedly until all the LEDs above the group
button light up.
3. Hold the tint remote control very close (< 5 cm) to the new tint product
(or to its radio controller).
4. Hold down the group button until the tint product begins to blink.
The feedback display will first blink red evenly; then, it will begin to
blink more quickly.
This means that the tint remote control has found a signal.
Continue to hold down the group button until the new light flashes 3
times to indicate that it has been connected to the tint remote control.
Keep holding down the group button until the tint product blinks again
one time, which shows that it has been assigned to default group
(=group 1).
5. If desired, you can select a different group by repeatedly pressing the
group button (middle LED = group 2 etc.).
After approx. 10 seconds, the new tint product will be added to the
selected group and the feedback display will stop blinking. Wait this
long, not pressing any buttons during this time.
The procedure will then end and you can use the extended group as
normal.
tint-LED-PANEL
INSTRUCTION MANUAL
66