Muller licht tint 404028 Mode D'emploi page 67

Remove a tint product from the tint remote control
1. Switch the tint product off (to standby) with the tint remote control if
necessary.
2. Select the group you would like to change using the group button.
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired tint product by pressing the group button repeated-
ly. The tint product will signal that it has been selected by increasing
and decreasing its brightness. The tint product will blink in the order
in which they are stored in the tint remote control.
5. Hold down the standby button for approx. 5 seconds. The tint product
will then signal that it has been removed from the tint remote control
by flashing and then dimming.
Shift a tint product from one group into another group
1. Switch the tint product off (to standby) with the tint remote control if
necessary.
2. Select the group you would like to change using the group button. (If
you would like to add a tint product from group 2 to group 1, for ex-
ample, press the group button repeatedly until the middle LED above
the group button lights up).
3. Hold down the group button for approx. 5 seconds. The feedback
display will blink red/green.
4. Select the desired tint product by pressing the group button repeated-
ly. The tint product will signal that it has been selected by increasing
and decreasing its brightness. The tint products will blink in the order
in which they are stored in the tint remote control.
tint-LED-PANEL
INSTRUCTION MANUAL
67