Smart Home Ready - Muller licht tint 404028 Mode D'emploi

integrate the LED Panel into a smart home gateway.
1. Switch the tint product on and off 5 times (interval of 3 seconds)
2. Switch the tint product on again. Depending on the tint product, a short
cycle through the colors appears or the tint product flashes briefly. The
reset has occurred as desired and you can now use the tint product as
normal using your remote control or other Zigbee system.
Resetting the tint remote control
A reset will only be required in exceptional cases, such as when the tint
product no longer responds to the tint remote control after removing and
reinserting the batteries.
Resetting the remote control will delete all pre-defined group
settings and you will have to connect the tint remote control and
the tint products again afterwards.
1. Remove the battery compartment cover.
2. Use a pointed object or the battery compartment cover to press the
reset button on the back of the remote control.
3. Then, proceed as described in the section "Resetting the tint product"
and then as described in the section "Adding a new tint product". Each
tint product will then have to be connected individually one after the
other. If, for example, three bulbs belong to one group, you must repeat
the steps in "Adding a new tint product" 3 times.

Smart Home Ready

The tint products from MÜLLER-LICHT can be controlled using the latest
Zigbee radio standard 3.0 and are compatible with a range of light
tint-LED-PANEL
INSTRUCTION MANUAL
69