Adjusting The Throttle Cable - Stihl FS 120 Notice D'emploi

8
8
7
7
4
3
5
6
1
1
Loop handle without barrier bar
:
Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
:
Fit the clamp (6) and line up the
holes.
:
Fit washers (7) on screws (8) and
insert screws in holes. Screw on the
square nuts (1) as far as stop.
:
Go to "Securing the loop handle".
FS 120, FS 200, FS 250
A
9
4
10
Securing the loop handle
:
Secure the loop handle (4) approx.
20 cm (A) forward of the control
handle (9).
:
Line up the loop handle.
:
Tighten down the screws firmly –
lock the nuts if necessaey.
10 Sleeve*
* see "Guide to Using this Manual"
English

Adjusting the Throttle Cable

Bike handle only
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
:
Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
23